Vintage Rides. Permanent Vacation.
Out in the Wild Merch on Etsy

Moped Wrench Guides · How it works

How mopeds work: engine, clutch and pedal start

Jump to a section
  1. What makes a moped a moped?
  2. How does the engine make power?
  3. How does the power reach the wheel?
  4. How do you start one?
  5. Where should I read next?
  6. Quick answers
  7. Sources

Short answer: A moped is a motorized bicycle: pedals, a small engine of 50 cc or less, and an automatic clutch that sends power to the rear wheel. The classic engine is a two-stroke that burns oil mixed into the fuel. You start it by pedaling while holding a start or decompression lever, and the engine fires when you let go.

A moped looks simple because it is simple, and the interesting part is how little it takes to turn a bicycle into a road vehicle: a small engine, a clutch that thinks for itself, and a pair of pedals that never retired.

Moped Alley 2 Strokes T-Shirt by Moped Motel
Moped Alley 2 Strokes T-Shirt by Moped Motel. See the T-Shirts.

What makes a moped a moped?

The pedals. The word arrived in 1952, when Swedish journalist Harald Nielsen blended the Swedish words for motor and pedal. A traditional moped carries a crankset like a bicycle's, and it can be used alongside the motor or instead of it. The usual definition is a small motorcycle, most often 50 cc or less, and the Vienna Convention sets the ceiling at 50 cc. Many places add a speed cap of 45 km/h.

Pedals earned their place at the starting line. Pedaling a bike up to speed beat the old run-and-jump start of early motorcycles, and on mopeds that habit lasted into the 1990s.

How does the engine make power?

The classic pedal moped is a two-stroke, an engine with no oil sump. Its crankcase is part of the intake, so the oil rides in with the fuel. On a mixed-fuel bike the standard ratio is 50:1, which is 2.5 ounces of two-stroke oil per gallon of gas. Oil-injected bikes skip the mixing and carry a separate tank that feeds oil into the intake. The full story, with what the wrong ratio costs, is in No oil in the crankcase.

How does the power reach the wheel?

Every vintage moped has an automatic clutch. Not every one has a variator. The clutch is centrifugal, so it engages by itself once the engine reaches a certain speed and lets go below it, which is what lets the bike idle at a stop. On pedal mopeds the clutch is driven straight off the crankshaft. On kickstart mopeds it sits on the rear pulley and is driven by a V-belt. A variator, where fitted, is a belt-driven automatic transmission, and it has its own guide in Chain, sprockets, belts and variators.

How do you start one?

Put the bike on its center stand so the rear wheel is off the ground, then turn the pedals backward until the pedal on your side is nearly straight up. From there, the brand decides.

On Puch, Sachs, Minarelli, Morini, Garelli and Batavus, pull the left start lever, push the pedal down while holding it, and release the lever when the engine fires. On Derbi, Vespa, Honda Hobbit and Kinetic, pull the decompression lever instead, push the pedal down, and let go of the lever as your foot goes down. The engine starts the moment you release it. Motobecane and Peugeot work the same way, with the decompression lever on the right and the choke on the left.

Tomos does it backward. Kick either pedal backward and no center stand is needed. To pedal start any of the others off the stand, get to about 5 mph and pull the start lever while still pedaling. If the bike has a decompression lever, pull that first, pedal, then release it.

Moped parts and what each one does
PartWhat it does
EngineA 50 cc two-stroke makes the power. Oil is mixed into the fuel, so there is no oil sump.
Automatic clutchStays disengaged at idle and grips as engine speed rises when you twist the throttle.
VariatorBelt-driven pulleys on variated bikes that change the ratio automatically. Non-variated bikes run one fixed ratio.
Decompression leverReleases compression so the pedals can turn the engine over, then you let go and it fires.
PedalsStart the engine on pedal-start bikes and get the bike rolling.

Where should I read next?

Once the engine is running, the pedal start and clutch guide walks through the faults. When nothing fires, It won't start is the diagnostic path, and Know your bike helps you work out which of these systems you own.

Related: No oil in the crankcase, Premix, How much is a vintage moped.

Quick answers

What does moped mean?

The word blends the Swedish words for motor and pedal, and it dates to 1952.

Do mopeds have gears?

Most pedal mopeds have no gear shifting. An automatic centrifugal clutch handles the connection, and variated bikes also change ratio on their own. Some German models, such as Simson and Kreidler, use a manual clutch.

How do you start a pedal moped?

Pull the decompression or start lever, pedal or push to get the engine turning, then release the lever and the engine fires. Tomos bikes start by kicking a pedal backward and do not need the center stand.

What fuel does a pedal moped use?

A two-stroke runs on gasoline premixed with two-stroke oil. At 50:1, that is about 2.5 ounces of oil per gallon of gas.

What size engine does a moped have?

Usually 50 cc or less. The Vienna Convention sets the ceiling at 50 cc, and many places add a speed cap of 45 km/h.

Sources

General information from published sources and owner experience. Your bike, your state and your tools may differ, so check your own service manual and local rules. Moped Motel is an independent fan site, not a repair service. No seller, brand or channel mentioned here paid to be included or asked to be, and we have no affiliation with any of them.

More guides are on the Moped Wrench Guides page, with the sources. Want to meet the riders? See Feature Your Bike.

Woody Creek Moped Club T-Shirt by Moped MotelJapanese Moped Long Sleeve by Moped Motel

Vacancy for your closet

T-Shirts, hats, and customs. Checkout happens on Etsy.

Moped Motel is vintage two-stroke moped apparel. We print over 100 moped designs on t-shirts, long sleeves, hoodies, sweatshirts, hats and beanies, inspired by real Puch, Tomos and other classic mopeds. Everything is printed to order, and checkout is on Etsy.

// MOPED ARCADE

Think you know your mopeds?

Name That Moped, Pinball, Blackjack and Stack. Free to play.

Play now
Browse merchBuy on Etsy