Vintage Rides. Permanent Vacation.
Out in the Wild Merch on Etsy

Moped Wrench Guides · Guide 21 of 30

How to install a big bore kit, step by step

Bore Score And 7 Seized Kits Ago T-Shirt by Moped Motel
Bore Score And 7 Seized Kits Ago T-Shirt by Moped Motel. See the T-Shirts.

A top-end swap takes an afternoon if you go slow. Read the kit's own instructions first; where they differ from this list, they win.

Before you start

The job

  1. Let the engine cool, close the petcock and clean around the cylinder.
  2. Remove the exhaust, carburetor, intake manifold and head.
  3. Stuff a clean rag into the crankcase opening so nothing drops in.
  4. Slide the stock cylinder off. Remove one wrist pin circlip, push the pin out and lift the piston away. Note which way the arrow points.
  5. Inspect the small-end bearing. Replace it if it is rough or loose.
  6. Clean the base surface and fit a new base gasket.
  7. Fit the rings to the new piston with each ring gap on the locating pin. Check ring end gap in the cylinder with feeler gauges against the kit spec.
  8. Oil the piston and fit it with new circlips, arrow toward the exhaust. Keep the rag in place while you do.
  9. Oil the bore and slide the cylinder down, compressing each ring with your fingers. Never force it.
  10. Fit the head and tighten the nuts in a cross pattern, in two or three stages, to the torque in your manual.
  11. Measure squish: lay soft solder across the piston through the plug hole, turn the engine over, then measure the squashed solder. Compare it with the kit's spec and adjust with gaskets if it is off.
  12. Refit the intake. Match the port to the manifold so there is no step, and make sure it is sealed with fresh gaskets.
  13. Fit the carburetor with a larger main jet than stock, then fit the exhaust and plug.

Tuning and break-in

Start rich and lean it in steps, reading the plug after each hard run. Run short heat cycles at varying rpm and avoid holding full throttle for the first tank. After the first cool-down, re-check the head nuts. Follow the kit maker's break-in instructions where they differ.

The Tomos Wikibook has a worked piston and cylinder replacement if you want a second set of pictures.

General information from published sources and owner experience. Your bike, your state and your tools may differ, so check your own service manual and local rules. Moped Motel is an independent fan site, not a repair service. No seller, brand or channel mentioned here paid to be included or asked to be, and we have no affiliation with any of them.

All guides are on the Moped Wrench Guides page, with the sources. Want to meet the bikes first? Read Bike histories.

Tangerine Dream T-Shirt by Moped MotelLightning Bolt T-Shirt (Upgraded) by Moped Motel

Vacancy for your closet

T-Shirts, hats, and customs. Checkout happens on Etsy.

Moped Motel is vintage two-stroke moped apparel. We print over 100 moped designs on t-shirts, long sleeves, hoodies, sweatshirts, hats and beanies, inspired by real Puch, Tomos and other classic mopeds. Everything is printed to order, and checkout is on Etsy.

// MOPED ARCADE

Think you know your mopeds?

Name That Moped, Pinball, Blackjack and Stack. Free to play.

Play now
Browse merchBuy on Etsy